Water heaters with two elements have two thermostats.
Gas hot water heater tripping breaker.
Most electric water heaters have 2 heating elements.
One on top and one on the bottom.
So you go and reset the circuit breaker.
The heating element is the part of your water heater that heats the water.
Your water heater reset button is a safety device that shuts off power to your water heater when the water temperature inside it exceeds 180 degrees fahrenheit.
There are three possible explanations for a breaker being tripped by a hot water heater.
Okay with that out of the way let s look at the possible problems that are causing your electric water heater to trip your breaker.
The most likely cause of the limit switch tripping is a bad thermostat.
Your water heater trips the circuit breaker in your house.
In this following article we shall talk about the issues which cause the electric water heater circuit breaker to keep tripping and how to troubleshoot these said issues.
You will cause a fire and burn your house down.
The reset button is also sometimes referred to as the eco emergency cut off switch or high limit safety thermostat switch.
Then after a few.
Burnt out heating element.
What does it mean if your hot water heater keeps tripping the reset.
It is never never never that the breaker is too small for the water heater.
When a water heater starts tripping the eco repeatedly it s time to call a plumber for service.
This helps protect you from getting burned or scalded by the excessively hot water.
Water dripping on the electrical lines a problem with the unit s thermostat or a problem with the breaker.
If the electric water heater was working fine then the breaker keeps tripping the worse thing you can do is install a larger circuit breaker.
There s a good chance that the water in the tank is dangerously hot and since the problem is usually caused by a failed component it won t get better until the bad part is identified and replaced.
The hot water heater reset is actually a high limit safety thermostat switch that disconnects the power to the water heater if.
The first and most important thing to understand is.
Internal circuit it might just be a simple wiring issue causing your breaker to trip so turn off the power and open the panel and check the part where your heater is.
