The regulation also mandates that steel and wrought iron pipe be marked with labels reading gas and astm d 2513 the code prohibits the use of cast iron pipes in residential gas piping installations.
Gas pipe union in attic.
If your old appliance is connected with a steel gas pipe and you re installing a new appliance buy a gas appliance connecting kit and replace the steel gas pipe with the flexible gas supply lines stainless steel tube.
We will discuss some of the basics of inspecting gas piping.
The irc s chapter 24 provisions also mandates standards for steel and wrought iron pipe.
Blue stuff might be megaloc teflon thread sealant.
Are there any rules or safety concerns about running a new gas through the wall into the attic and then dropping it down through the wall.
The branch line terminates in a drop line which is a vertical pipe dropping down to the appliance from an overhead branch line.
Supply branch and drop lines or risers.
Some say yeah but hide them some say no way some say sure i 39 ve done it for years.
Any union in a gas line must have a valve in front of it.
Or rather is it legal to use unions to connect gas pipe.
Ask this old house plumbing and heating expert richard trethewey explains how gas piping is installed in a home.
Subscribe to this old house.
I was replacing some gas pipe and the guy at the plumbing wholesaler asked if i wanted to do the connection with a union or a.
Companion flanges are code approved when dealing with two points of piping where you cannot gain access to the opposite end of piping.
Older houses often have threaded steel gas pipe.
Yes unions are generally acceptable to join pipes backwards.
I have just purchased a house where the gas line for the dryer is copper.
Branch lines run to individual appliances.
The laundry room is built on a slab.
And all the usual warnings go along with gas piping to be sure to test well afterward.
That said it s always good to check with your local inspector to ensure there aren t any local issues with it.
Make connections to steel gas pipe.
Can you use unions to connect gas pipe.
And yes the flex pipes are generally acceptable for the final appliance connection.
It was run in an unprofessional manner in that it runs up from the basement and then along a door threshold and finally through a wall.
